2024 H & S W3243

2024

H & S

W3243

Yes

322MSW4013

New

430 Bushel, 2 Speed, Tandems, Floatation Tires, Splash Guard, Hydraulic Endgate, Upper Beater The heavy-duty series of H&S manure spreaders feature a massive unitized welded frame with heavy floor supports, side stakes, and wrap-around steel front corners. Strong rear main beater side panels are slanted for clearance and wider spread, and then welded to the strong 5″ U-channel side members. Compares with any on the market. The side flares on all H&S heavy-duty manure spreaders are made of 10-gauge g210 culvert grade galvanized steel. Sides, front panel and both sides of the rear hydraulic endgate use fiberglass reinforced plywood to provide for easy cleaning and minimal freeze-up. The solid virgin grade poly floor allows for considerably less torque to move a heavy load. The two-speed apron drive is standard equipment. The 29″ diameter beater has two styles of replaceable beater paddles. Half of the 14-beater paddles are blunt for widespread, and the other half are a sharp ripper-type for cutting and shredding. Beater side wiper blades are also standard equipment. The hydraulic endgate features 2 cylinders with hydraulic lines running through a 3″ x 3″ tube under the floor for protection. The upright position of the hydraulic cylinder stroke allows the gate to lift with the least strain at pivot points. Special cast steel alloy apron idler slides are used instead of idler sprockets, making for years of dependable service. Adjustment for the main apron is easily made by simply loosening the two side bolts and drawing up the long bolt. The beater drive gear box is 1:1.5 bevel gear oil bath equipped with a 4-jaw over running clutch for beater shut-off. The apron drive is a 50:1 bronze worm gear with shear bolt protection. PTO Apron Low-Speed/540 RPMs: 4′ 8.5″ per minute. PTO Apron High-Speed/540 RPMs: 8′ 8.5″ per minute The top beater provides load leveling and spreading of high heaped loads. The SW3243 (western) has additional features to other heavy-duty models such as double main frame channels, additional floor supports, 1045 hardened drive shaft, and #80 drive chain. A front splash guard is standard equipment. Greaseable bearings

Yes

Pull-Type

2

Chain

Yes

Hydraulic

Tandem

Mechanical

Yes

540