2024 HERCULES R/T COMBINATION

2024

HERCULES

New

MHerc

Brand New Hercules Tandem Axle A double Trailers - VOLUME: 51 cubic metres. DIMENSIONS: 8920 x 2420 x 2300mm approximately internally. LONGMEMBERS: Hercules extruded one piece sections. FIXED SIDES: 5mm high tensile with extruded splash guards, corners and top rails. (top rails will be huck bolted)(front and side sheets wrapped in white) DECALS: Hercules decals with pin stripes in top rails and lower corners. FLOORS: 6mm high tensile. FRONTS: 5mm high material with extruded round corners, with 2 wheel submarine door fitted (location to be discussed) TAILGATE: Rear hinged, over centre manual control bottom opening with 3 locking dogs, air operated with switch at rear. GRAIN DOOR: Yes, wide mouth with removable chute. GRAIN LOCKS: Yes, one set in rear posts. TARPS & BOWS: Manual Red PVC roll tarp with fibre glass hoods and flex bows, manual handle SUBFRAME: Fabricated 6mm P-Beams with 150x16mm bottom flanges. HOIST: Delta Well mounted type of 35 tonne capacity. REAR LIGHTS: LED tail lights in rear aluminium quartergaurds with reverse lights and buzzer with additional lights in panels on tailgate, with work lights underneath panels. SIDE LIGHTS: 27 x LED side lights per side with centre indicator. MUDFLAPS: Hercules fitted to front and rear. MUDGUARDS: Full plastic type over rear tandem, with chrome inserts. PAINTING: Subframes sandblasted, primed and finished in 2-Pack paint. (aluminium natural) (Bright Red) TYRES: 8 off 11R 22.5 Haulmax ATT202. RIMS: 8 off 8.25 x 22.5 10-285 Alcoa, all LVL-1. AXLES: 2 off Hendrickson drum brake type with 10 x 285PCD grease filled hubs with EBS sensors on one axle and automatic slack adjusters on both axles. SUSPENSIONS: Hendrickson Intrax series vertical mount HD shock absorbers with sealed air bags. BRAKES: Air Brake Corp multivolt EBS. to comply with all Australian Design Rules. LANDING LEGS: Dual manual two speed wind down type. KING PIN: 50mm demountable with removable block. SKID PLATE: 12mm full width reinforced plate. DIVERTER VALVE: Yes, Manual on side of chassis. YARD RELEASE: No. RAISE LOWER: No. LOAD GUAGE: Yes, standard air guage in front of rear group. TOOLBOX: Yes aluminium fitted to chassis. WATER TANK: Yes stainless round fitted to chassis. SPARE WHEEL CARRIER: Yes single under chassis. COUPLINGS: PBR M&F Bayonet air fittings, 7 pin electrical base, EBS base and Tema 10000 male hydraulic coupling at front of skid plate. TOWBAR/COUPLING I-Beam type with 303 AUD Ringfeeder, safety chain lugs, 7 pin electrical base. EBS base, M&F Bayonet air fittings and Tema 10000 male hydraulic coupling. STANDARD EQUIPMENT: Shovel racks, spreader chains, fold down ladders, safety props and regulation rear markers. Dolly - SUBFRAME: Hercules heavy duty fabricated beam. DRAWBAR: "A" frame with a 50mm weld on Ringfeder eye, complete with male and female bayonet air fittings, 7 pin electric plug, wind down leg. SUSPENSION: Hendrickson Intrax with sealed air bags. AXLES: 4 off Hendrickson drum brake type with 10 x 285 PCD grease filled hubs with 420 x 180 brake drums second and fourth axle with ABS sensors and automatic slack adjusters on all axles. TYRES: 8 off 11R22.5 Haulmax ATT202. RIMS: 8 off 8.25 x 22.5 10-285 Alcoa, all LVL-1. BRAKES: Air Brake Corp multi volt EBS with roll stability system to comply with all Australian Design Rules. TURNTABLE: Jost JSK37 Greaseless. LOAD GUAGE: Yes, on front dolly frame. PAINTING: Subframe sandblasted, primed and finished in 2-Pack Paint. MUDFLAPS: Hercules where applicable. MUDGUARDS: Full plastic over tandem group, with chrome inserts. REAR LIGHTS: LED type tail lights in rear pressing with reverse and number plate lights. STANDARD EQUIPMENT: Aluminium checker plate front & rear of turntable, Regulation rear markers. LEVEL 2/3 ACCESS ONLY - 65.0t at GML - 67.0t at CML - 67.0t at HML SPECIFIC APPROVED ROUTES - 72.5t at GML - 74.5t at CML - 74.5t at HML $361,400 plus GST for the combination plus registration. PBS application costs are included in pricing.