2022 EBY BULL RIDE

2022

EBY

4A2LD5322N3006465

中古

9004682-3006465

SPECIFICATIONS: -LENGTH: 53' -WIDTH: 102" -HEIGHT: 13'6" -KING PIN: 30" DEEP, 49" HIGH -FRONT DROP: 33-3/4" -REAR DROP: 27-3/4" -LANDING GEAR: STD DROP LEGS -----RUNNING GEAR----- -SUSPENSION: HENDRICKSON AIR RIDE – SU15112 INTSUSP.12000 -DUMP VALVE: MANUAL W/ PRESSURE GAUGE LOCATED IN FRONT OF AXLES -AXLE SPREAD: 10'1" -AXLE LOCATION: NO TUCK -AXLES: HENDRICKSON -HUBS: DUCTILE -DRUMS: CAST -BRAKES: 7" HXS -ABS: 2S/1M -WHEEL SIZE: 22.5 -WHEEL TYPE: (8) ALUMINUM WHEELS- ALCOA LVL ONE -TIRES: 295/75R22.5 GENERAL RA -GVWR: 66,000 LBS -----FLOOR----- -MATERIAL: .115 RIDGED ALUMINUM DIAMOND PLATE -DRAINS: (2) LIFT OUT FLOOR DRAINS IN LIEU OF STD CLEAVER STYLE --WITH PULL UP HANDLES AND SPRING PIN TO LOCK IN --NOTE: USE SA00609 LATCH AS LOCKING PIN AT BOTTOM OF LIFTOUT DRAINS -----FRONT END----- -PANELS: MILL FINISHED ALUM -EXTRUDED CORNERS: MILL FINISHED ALUM -VENTS: (4) PUNCHED --NOTE: STD PUNCHED HOLES, NO COVERS NEEDED BUT SUPPLY BLACK PLUGS -HANDLES/STEPS TO ACCESS VENTS: NO -TIRE CARRIER: NONE -LIGHTED SIGN: ALUMINUM BOX --NAME: SEMPER FI LOGO -NOSE BOX: SINGLE PLUG -ADD 24” LONG HOSE HANGER BRACKET ON NOSE 65” FROM BOTTOM OF NOSE -----REAR END----- -ROAD SIDE: NEW STYLE (1) PIECE ROLL UP DOOR --NO TODCO LATCH REQUESTED ON TRAILER -CURB SIDE: PUNCHED PERM PANEL TO MATCH SIDES -WASH OUT: YES -BUCK PLATE COVER: MILL FINISHED ALUM -TOW HOOKS: YES -BUMPER VERTICAL: (2) 13" X 3" ON CORNERS --(2) VERTICAL BUMPERS BELOW HORIZONTAL BUMPER -BUMPER HORIZONTAL: FULL WIDTH 4" --(2) 48" BUMPERS ON EITHER SIDE OF ROLL UP DOOR -----ROOF----- -MATERIAL: ALUMINUM -HATCH: (3) CENTERED – LOCATE (1) IN CENTER OF FRONT COMPARTMENT, (1) IN CENTER OF TOP DECK, (1) IN CENTER OF JAIL -----SIDE ASSEMBLY----- -HOLE PATTERN: A -MATERIAL: MILL FINISHED ALUM -PANEL RETAINER CLIPS: YES -CENTER SIDE DOORS: (4) 28-1/2" WIDE RS -CLEAN OUT DOOR: (1) 24" TALL X 16-3/4" WIDE, RS -REAR SIDE DOORS: RS ESCAPE DOOR WITH FOLDING LADDER -----CLOSURE SYSTEM----- -CLOSURE PANELS: BLACK COROPLAST -PLUGS: BLACK, SIDE DOORS ONLY -----FRONT COMPARTMENT----- -LENGTH: 120-5/8" -DECK RAILS: CENTERED 51-1/2" DECKS -DECKING: YES, USE NEW 14" WIDE PLANKS -DECK STORAGE: YES -----FRONT PARTITIONS----- -ROADSIDE TOP: 2/3 84" L C.B. W/ DROP RAMP --1" ON 5" CENTERS -CURBSIDE TOP: PERMANENT PANEL, TUBE STYLE --NOTE: MAKE SURE TUBES DO NOT INTERFERE W/NOSE DECKING WHEN DECK IS IN – SO WASHING WATER CAN RUN OFF DECKING TOWARD PARTITION -ROADSIDE BOTTOM: TUBED PERMANENT PANEL -CURBSIDE BOTTOM: SWING GATE, TUBE STYLE WITH SPRING PIN -FUNNEL GATE: FOLD TO CORNER -----CENTER COMPARTMENT/BOTTOM----- -LENGTH: 28' -DOWN RAMP: EXTEND DOWN TO BELLY, NO STEP -DECK RAILS: NONE -DECKING: NONE -DECK STORAGE: NONE -GATES: (1) CENTERED --GATE TYPE: TUBE STYLE, MOUNTED 4” OFF FLOOR --SPRING PIN ON BOTTOM -----CENTER COMPARTMENT/TOP----- -LENGTH: 28' -DECKING: NONE -DECK STORAGE: NONE -GATES: (1) CENTERED --GATE TYPE: TUBE STYLE --SPRING PIN ON BOTTOM -GATE OPTIONS: LOCATE 4" OFF FLOOR -----REAR PARTITION----- -ROADSIDE TOP: SWING (ADD SPRING PIN IF POSSIBLE) -CURBSIDE TOP: DROP RAMP ONLY --1" ON 5" CENTERS FOR ALL RAMPS IN REAR PARTITION -BOTTOM: CENTER SWING --NOTE: USE CHAIN AND CLIP UNDER CELLAR FOLD OVER TO PIN/ATTACH TO BULL BAR TO LOAD BELLY --NOTE: USE L-SHAPED SPRING LOADED PIN PON BOTTOM, AND SPRING LOADED PIN W/ CHAIN ON TOP LATCH OF GATE ABOVE CELLAR FOLD OVER DOOR. -REAR TUBE GATE PACKAGE: YES -FUNNEL GATE: TUBE STYLE FOLD TO CORNER FUNNEL TO LOAD JAIL AND FUNNEL TO RAMP --NOTE: MOVE SPRING PIN TO TOP OF BAR ON FUNNEL TO PREVENT HOGS FROM CATCHING LATCH --NOTE: INSTALL PIN ON BULL BAR TO HOLD THE DOWN RAMP COVER IN A VERTICAL POSITION AS WELL -----REAR COMPARTMENT----- -LENGTH: 15' -PULL OUT CHUTE: LENGTH 126" --1" ON 5" CENTERS -CHUTE SIDE: FOLD TO CORNER WITH SQUARED OFF CORNERS --CLOSE OFF GAP BETWEEN FTC AND BOTTOM OF JAIL -JAIL HOUSE: 3/4 L-SHAPED JAIL TUBED STYLE --PERM FENCE TO BE SOLID 2’ UP --NOTE: INCLUDE THIS ON SWING GATE FOR ¾ JAIL -----LIGHTS----- -SIDE LIGHTS: (9) TOP, (9) CENTER, (5) BELLY, PENNY STYLE -SIDE REAR POST: (8) UP EACH REAR SIDE POST -REAR HEADER: (3) BRAKE, CLEARANCE -REAR POST: (2) HIGH MOUNT TURN, CLEARANCE -BUCK PLATE: (2) BRAKE, CLEARANCE, (1) TURN CLEARANCE EACH SIDE --LIGHT NOTES: --CHANGE ALL EXTERIOR CLEARANCE LIGHTS TO “CLEAR PENNY” TRUCK BRAND LIGHT LI23731 LI23732 --CHANGE ALL EXTERIOR STOP/TURN LIGHTS TO CLEAR TRUCK BRAND LIGHT -INSIDE LIGHTS: (9) TOTAL LED, (1) ADDITIONAL LIGHT MOUNTED BELOW THE JAIL TO SHINE ON PULLOUT RAMP. LIGHT TO HAVE OWN SWITCH MOUNTED ON LIGHT BOX. --LOCATION: (1) PER COMPARTMENT --NOTE: LOCATE UNDER JAIL ON ROADSIDE WALL, TO SHINE DOWN ONTO PULLOUT RAMP --NOTE: USE CLEAR RECTANGULAR MIDSPAN TURN LIGHTS (LI00315/LI00316) -BACK UP LIGHTS: YES -----MISCELLANEOUS----- -MUD FLAPS: BLACK RUBBER WITH SS EBY WEIGHTS -CLOSURE STORAGE: SADDLE STYLE IN BETWEEN SPREAD -TOOL BOX: NONE -DOCUMENT HOLDER: ROUND PLASTIC STYLE –LOCATED ON NOSE -----NOTES----- -TUBE ALL GATES -SPRING PINS ON ALL POSSIBLE GATES

アルミニウム

エアライド

アルミニウムフロア

タンデム

固定スプレッド

16.15 m

259.08 cm